Your Reliability Engineering Professional Development Site
In my prior article, the assumptions behind SPC were discussed in detail except for the analysis. There are two types data that may be analyzed, Counts and Measurement variables. This article focuses on normally distributed measurement variables, and the construction and usage of $-\bar{X}-$ and R charts.
[Read more…]
The operating characteristic curve is used to understand lot sampling plan. It graphically provides a relationship between the unknown lot’s defect rate (or total) and the probability of the specific sampling plan to accept the lot. Very good plans discriminate between good and bad lots. Poor plans may accept bad lots or reject good lots to easily. [Read more…]
I recently received a question concerning what sample size to use when assessing call center calls. Not a lot of information in the request, so my answer was rather general. And, thought it might provide some insight to others facing sample size questions of their own. [Read more…]
There a few different ways to sample a lot (or group) of material to determine if it has an acceptably low failure rate (or proportion that are considered ‘bad’). The following is an example of the sequential sampling method, which happens to be rather efficient by generally using the fewest samples for the same risk protection. [Read more…]